mobile-menu-icon
GM Authority

Express 2500 Grade Breaking

Viewing 2 reply threads
  • Author
    Posts
    • #141264
      RodR
      Participant

      Can anyone shed light on why my 2015 Express 2500 displays “Grade Breaking Enabled” on slight hills but not on anything steep. Dealer and GM service cannot find anything that says my vehicle should have this feature. It is not listed in the build from the factory. They have stated that it’s only available on Silverado Pickup’s

    • #141364
      abgoodyear
      Participant

      Page 5-36 and Page 9-25 in your owners manual should shed some more light on the Grade Braking.
      From experience, it seems to work most on long declines. It takes some time for the system to kick in and uses the transmission and engine to slow the vehicle down. If I had to bet, I’m guessing that the steep hills you are going down are fairly short relative to the hills?

    • #141432
      arniedz
      Participant

      I have a 2016 Express Van and a 2014 CTS both have the 6-speed automatic which has (down) grade breaking. It is only active in auto shift mode with cruise control engaged. The display may be shown on the first down grade transmission down shift during a cruise engagement. However, the engine tachometer can be used to see the the grade shift points. My CTS will hold the selected speed within 3 mph. My express van’s greater mass (8600 lb GVW) results on more speed over-run (5-7 mph). I usually click down the cruise to allow for this. Grade braking is one of the most important and useful transmission improvements made in the newer transmissions. It keeps you from getting speeding tickets on freeway down grades and saves brake pad wear too. Note that the old 700R4 rear wheel drive automatic had no engine breaking in 4th gear as it had a one-way clutch (in overdrive) , thus could over-speed the selected speed by as much as 15 mph or more. This led to more brake pad wear (and speeding tickets) as most drivers never read the owners manual that calls to move to D3 or D2 to hold vehicle speed. That works well because D3, D2 and D1 engage a band so that you have engine breaking. Bottom line is that grade braking is active on all down grades steep or not – as long as you have ENGAGED the cruise control. With out down-grade engine breaking on very long steep down grades – over use of vehicle brakes can lead to enough heat to boil brake fluid and then complete loss of all vehicle braking so be happy that you have it – you car is now much safer.

Viewing 2 reply threads
  • You must be logged in to reply to this topic.

Subscribe to GM Authority

For around-the-clock GM news coverage

We'll send you one email per day with the latest GM news. It's totally free.